Publicité
Les langues disponibles
Les langues disponibles
G
®
THERMASGARD
Display screen
Reading
Temperature
Use the EtherCAT interface to program the LCD display.
With only one output value selected, the display is static;
with several values selected, the display is cyclical with one after the other.
In the first line the value is displayed and in the second line
the corresponding unit. The third line is empty
by default if there are no customised inputs.
The entire display in the 7-segment range as well
as in the dot-matrix range can be customised.
When the supply voltage is applied, the device performs a function test for the display and bar graph.
This takes approximately 30 seconds, after which the device is ready for operation.
In the absence of a bus connection to the device, the message "ERR no link" appears in the display..
IN
OUT
RUN
Ether CAT P
1. LED
off
illuminated
blinking
2. LED
off
illuminated
blinking
3. LED
off
quickly blinking
slowly blinking
illuminated
The status LEDs are next to the cable connection.
ATM2 - EtherCAT P
Programmable
display screen
LED status display
"IN"
no
connection to upstream EtherCAT module
LINK: connection to upstream EtherCAT module
ACT: communication with upstream EtherCAT module
"OUT"
no
connection to downstream EtherCAT module
LINK: connection to downstream EtherCAT module
ACT: communication with downstream EtherCAT module
"RUN"
EtherCAT module is in "Init" state
EtherCAT module is in "Pre-Operational" state
EtherCAT module is in "Safe-Operational" state
EtherCAT module is in "Operational" state
7
Rev. 2021-V11
Publicité
