Francis Francis X1 Manuel D'instructions page 10

ENGLISH
LIMITED WARRANTY CONDITIONS
The warranty does not cover repairs caused by:
- Failures due to limescale or not descaling regularly
- Failures due to operation with different power supply to that indicated on the data plate
- Failures due to improper use or use not conforming to the instructions
- Failures due to internal modifications made to the machine.
The cost of repairs on machines that have been previously carried out by non-authorised assistance centres shall be at customer's full expense.
If the machine is kept on without having filled the boiler with water any damage caused will not be covered by the warranty.
Moreover:
- Do not tap filter-holder on the drip grill (L) or body
- Do not put any machine parts in the dishwasher
- Keep the machine, particularly the area where the water tank resides dry at all times.
Non observance of these points could create problems to the body that are not covered by the warranty.
Keep the original packaging (at least for the warranty period). This will be useful if the machine needs to be taken to the centres for repairs. Any damage
caused by transportation without suitable packaging is not covered by the warranty.
TROUBLESHOOTING
PROBLEM SOLVING
- Slow acoustic impulses If this occurs when the machine is switched on: flip the coffee/hot water switch (B) and steam
(1 per second) switch (C) upwards. If this occurs when the coffee or hot water is dispensed, flip the coffee/hot
water switch (B) upwards. If it occurs during the steam supply, close the steam valve and set the
selector steam/coffee (C) on the coffee position again
- Rapid acoustic impulses Carry out the following operations: switch off the machine; fill the water tank; place a receptacle
(5 per second) under the steam wand and open the steam valve; switch on the machine; wait for water to flow out
of the steam wand; close the steam valve; wait for the green light (E) to come on
- Coffee has a foul taste The machine is dirty: see chapter on CLEANING AND MAINTENANCE
- The machine does not Flip the coffee/hot water switch (B) upwards
dispense coffee
case a) no water in the tank: fill the tank with water; put a receptacle under the steam wand and
open the steam valve; flip the coffee/hot water switch (B) downwards; wait for water to flow out of
the steam wand then close the steam valve; check that coffee dispensing is restored
case b) steam switch (C) is in down position (steam): flip upwards; refer to chapter on COFFEE
PREPARATION AFTER STEAM DISPENSING
case c) when the machine has been on for a lengthy period without dispensing any beverage: open
the steam valve and press the coffee button (B) until water comes out of the steam pipe, then close
the valve and make coffee as directed
- When the valve is opened, Check that switch (C) is in down position; check that light (E) is on; switch off the machine by means
no steam is produced of general switch (A); wait for it to cool down (at least one hour). Remove any obstruction in the
steam hole
- Water leak inside the Switch off the machine. Disconnect the machine plug from the electrical outlet
machine
- Steam is dispensed but the Remove any obstructions in hole (K); make sure that the switch (C) is in down position and that light
milk does not froth (E) is on
- Water leaks from the unit Switch off the machine and disconnect the power cord. Wait for the machine to cool down. Remove
when dispensing any solid residues from the bottom of the brewing head.
- When the machine is Check the status of the domestic electric electrical outlet protection switches. Check the
switched on light (D) does connection of the electrical cord to the machine. Plug in the electrical cord to the socket again
not come on
RECOMMENDATIONS
To obtain a top-quality espresso, remember to:
- warm up the cups before using them (on the cup warmer or using hot water)
- prepare the coffee only when the green light comes on and switch (C) is in up position
- dispense a small amount of water after use to remove coffee residues from the unit
- switch on the machine at least 10 minutes prior to use, NB: before switching on, insert the filter-holder
- change the water in the tank at least once a week
Moreover, the use of soft water is recommended so as to reduce the amount of limescale deposits in the machine.
All manuals and user guides at all-guides.com
14
WICH
Bei Verwe
- Die Be
- Berühr
- Um Fe
- Die Ma
- Den Ne
- Die Ma
- Der Ge
- Nicht i
- Das Ka
- Die Ma
- Die Ma
- Die Ma
- Nachd
PERSISTENCE OF THE
PROBLEM
- Diese M
Contact assistance
- Der He
- Sollten
Contact assistance
- Die Ma
- Kontro
Contact assistance
- Der He
Contact assistance
- Bei Un
- Die Ma
-
Achtung:
durchgefü
Contact assistance
EINR
Contact assistance
Bevor Sie d
Contact assistance
Vergewiss
angeschlo
Contact assistance
Den Filterh
Entfernen
Contact assistance
Saugschla
Die Masch
INBE
Kontrollie
Den Schal
Sekunde e
Bei der e
Kaffeeber
Wenn die
Die Masch
austreten
HINWEIS:
Filterhalte
*die M
*die M
*der W
Achten
Lassen
wurde
und Da
Fachp
verant
Stellen
6A Stro
aufste
DIE