HP PageWide XL Serie Informations D'introduction page 5

Turn off the printer in either of the following cases:
During a thunderstorm
●
During a power failure
●
Take special care with zones marked with warning labels.
Ventilation measures for your location, whether it be the office, copy room, or print room,
should meet local environmental health and safety (EHS) guidelines and regulations.
Electrical shock hazard
The printer uses a power cord that must always be unpluged to service the printer.
WARNING!
hazardous voltages capable of causing death or serious personal injury.
The printer requires a building installation circuit breaker, which must meet the
requirements of the printer and should be in accordance with the Electrical Code
requirements of the local jurisdiction of the country in which the equipment is installed.
To avoid the risk of electric shock:
The printer must be connected to earthed mains outlets only.
●
Avoid overloading the printer's electrical outlet with multiple devices.
●
Do not remove or open any closed system covers or plugs.
●
Do not insert objects through slots in the printer.
●
Take care not to trip over the cables when walking behind the printer.
●
Insert the power cord securely and completely into the wall socket and printer inlet.
●
Never handle the power cord with wet hands.
●
Fire hazard
To avoid the risk of fire, follow all the precautions.
The customer is responsible for meeting the printer's requirements and the Electrical
●
Code requirements according to the local jurisdiction of the country where the
equipment is installed. Use the power supply voltage specified on the nameplate.
Use only the power cord supplied by HP with the printer. Do not use a damaged
●
power cord. Do not use the power cord with other products.
Do not insert objects through slots in the printer.
●
Take care not to spill liquid on the printer. After cleaning, make sure all components
●
are dry before using the printer again.
Do not use aerosol products that contain flammable gases inside or around the
●
printer. Do not operate the printer in an explosive atmosphere.
Do not block or cover the openings of the printer.
●
Mechanical hazard
The printer has moving parts that could cause injury.
ENWW
The internal circuits of the built-in power supplies and power inlet operate at
Safety precautions
3