Motorisation+ EM4X Instructions D'installation Et D'utilisation page 9

DESCRIPTION
four times for output 4
five times for output PRESET
(button 1 = output 1, button 2 = output 2, button 3 = output 3,
button 4 = output 4).
To find out which function the receiver output activates, refer to
the manual of the control unit or device on which the receiver
is to be installed
The LED on the receiver will flash a number of times equal
to the number of the output selected, with 1 second pauses
between flashes
Press the button of the remote control to be memorised within 7
seconds, holding it down for at least 2 seconds
If the memorisation has been successful, the receiver will give
one long flash
To memorise another remote control on the same output,
repeat point 3
If no commands are given for 7 seconds, the receiver
automatically quits the programming mode
4.2 MANUAL DELETING A REMOTE CONTROL
DESCRIPTION
Press the button on the receiver until the LED lights up (about
3 seconds)
Press the button of the remote control to be deleted within 7
seconds, holding it down until the LED on the receiver goes
out. Release the remote control button
About 1 second after the button is released, the LED on the
receiver starts to flash
Confirm the deletion by pressing the button on the receiver
If the deletion has been successful, the receiver will give one
long flash
If no commands are given for 7 seconds, the receiver
automatically quits the programming mode
EXAMPLE
+ + +
+ + + +
+ 1s + 1s
2s
3s
EXAMPLE
>3s►
0,5s 0,5s
3s
9