Preliminary Checks; Installing The Product - Motorisation+ Em4X Instructions D'installation Et D'utilisation

LED
GREEN
EM4X

3 - PRELIMINARY CHECKS

WARNING - before installing the product, perform the following checks and inspections:
• Check that the intended mounting surface is solid and does not allow vibrations
• Use electrical connections suitable for the currents required
• Check that the power supply conforms to the values in the technical specifications
• Connect an antenna; without an antenna, the range is cut to a few metres. The antenna must be
installed as high up as possible and above any metal or reinforced concrete structures. The antenna
cable must be type RG58 and no more than 10 metres long.
• If it is not possible to fit an antenna, the range can be increased significantly by connecting an
electric cable and keeping it straight.

4 - INSTALLING THE PRODUCT

Connect the radio receiver with the power supply disconnected and for EM4X models check
the connection position following FIG.1 (pag. 2).
4.1 MANUAL MEMORISING A REMOTE CONTROL
WARNING: When the memorisation phase is activated, any transmitter within the reception
range may be memorised. To reduce the receiver's range, disconnect the antenna temporarily.
DESCRIPTION
Press and release the receiver button a number of times equal
to the number of the output to be activated:
once for output 1
twice for output 2
three times for output 3
8
BUTTON
PLUG-IN
J1
+ (~)
12/24
Vac/Vdc LINK
- (~)
OUT 1
UNIVERSAL
OUT 2
J1: = 12 Vac/Vdc
= 24Vac/Vdc
OUT1-OUT2= impulsive monostable output
BUTTON
LED
GREEN
EXAMPLE
+
+ +