Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7. Removing rebar during bending operation
When bending out at a low speed in "bending by
eye measurement", the rebar can sometimes get
caught in the bending roller due to its own flexure.
If this occurs, you can return the bending roller to
the home position by pulling the switch again after
setting the setting dial to the "return" position.
This is the same method used to remove the rebar
when it gets caught during cutting operation. (Fig.
22)
8. Using hole to fix unit in place
A hole is provided at the center of the unit to fix
and stabilize it. This hole comes in quite handy
when used in the following manner. (Fig. 23)
For bending operation when the unit is fixed
to a work bench.
This hole will prove very convenient when the
unit is bolted to a suitable work bench.
(Bolt size M10, less than W3/8.)
Fig. 22
Tail
Bolt
cover
Set
screws
Hole to fix
unit
Nut
Fig. 23
English
21
Publicité
Table des Matières
