Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
Removing (Fig. 8)
Set the setting dial to the "RETURN" position
as shown in Fig. 8 and pull the switch trigger
again.
SERVICE LIFE AND REPLACEMENT OF THE CUTTER
1. Service life of cutter (Fig. 9)
Repeated cutting of the rebar can result in the
"wear and tear", "deformation", "nicked edges",
etc. Using the cutter under such circumstances will
not only damage the machine but also there will
be a fear of the broken cutter fragments flying
around.
Replace it with a new cutter after cutting no more
than 5,000 pieces of rebar.
2. Before removing the cutter
(1) Pull the switch lightly and let the upper cutter
move slowly. When the hexagon socket bolt
that fixes the upper cutter comes out of the
cam cover, turn the switch OFF and stop the
motor.
(2) Unplug the power cord from the receptacle.
3. Removal
If you remove the hexagon socket bolt using
the provided Allen key, you can remove the
cutter. (Pushing the cutter guard up in the
direction of the arrow shown in Fig. 10,
facilitates removal of the upper cutter.)
Removal of the lower cutter can be easily
made if the lower cutter is wrenched with a
Phillips head screwdriver as shown in the
following diagram. (Fig. 11)
16
Fig. 8
Blade
Fig. 9
Hexagon
socket
bolt
Fig. 10
Cutter
guard
Upper
cutter
Lower
cutter
Publicité
Table des Matières
