auna 10003999 Mode D'emploi page 9

All manuals and user guides at all-guides.com
SPEAKER RECEIVERS
1 Remove the door of the battery compartment.
2 Insert 6 pieces of 'AA' size ALKALINE batteries into the battery compartment with correct polarity
under the speakers, then replace the door of battery compartment, or connect the provided AC/DC
9V Adaptor to the DC input jack under the speakers, then plug it to the wall AC outlet.
1 Turn on the audio source to which the transmitter is connected with. The Signal LED on transmitter
will light up. Select a channel of the transmitter for best performance in your location.
2 Select the L/M/R (Left/Mono/Right) selector under the speakers, one to L and the other to R for the
best stereo reception. In case the audio device only provides Mono audio signal, select to M (Mono)
for the best mono reception.
3 Turn on the speakers by pressing both the Volume Up and Down Buttons simultaneously, the LED in
front of the speaker glows. To switch off the speakers, press both the Volume Up and Down Buttons
simultaneously again.
4 Push the "AUTO SCAN" button to get the best tuning reception under the speakers. When the but-
ton is pressed, frequency tuning starts automatically and it stops when a signal is detected. The
glowing LED will be changed to GREEN which represent proper reception. Adjust the volume to the
desired listening level by pressing Volume Up or Down.
Important Notes
• Keep a distance of 7 meters between speaker and transmitter, and then press " AUTO SCAN " button
for best tuning reception.
• Once the frequency is jammed, select another channel on the transmitter, then press " AUTO SCAN "
button again.
• The "BOOST BASS" button can be used to enhance the bass sound depending on your own music pre-
ferences. Turn the effect ON simply by pressing the button down, and pressing it once again to OFF.
• If the power of the transmitter is being cut off, or no audio signal is playing from the source, the
glowing LED on the speakers will be changed from GREEN to BLUE in 4 minutes, even if the frequen-
cy between speakers and transmitter is properly matched.
• Signal LED on the Transmitter would be cut off automatically if there is no/weak operation input
signal from audio source for 4 minutes. When the signal comes back, the transmitter will work again
automatically.
Operation
9
www.auna.de