DS Produkte Z 09575 Mode D'emploi page 2

GB
Dear customer,
We are delighted that you have decided to purchase our spray
mop.
Prior to using the product for the fi rst time, please carefully read
through the operating instructions and store them in a safe place.
If you have any questions, please contact customer service via
www.service-shopping.de
our website:
Proper use
❐ This product is designed for wet mopping all kinds of surfaces
(fl oors, stairs etc.).
❐ The product is designed for private use and is not intended for
commercial use. Only use it as described in the instructions.
Any other use is deemed improper.
❐ Defects arising due to improper handling, damage or attempts
at repair are excluded from the warranty. This also applies to
normal wear and tear.
Important notes
❐ Keep children and animals away from the packaging material.
Danger of suffocation exists!
❐ Only use accessories from the manufacturer.
❐ Do not allow the product to fall and do not subject it to severe
percussions.
❐ Maintain adequate distance to heat sources such as
stovetops, ovens, fi replaces or open fl ames etc.
❐ Do not subject the product to extreme temperatures, severe
changes in temperature or direct sunlight.
Product contents and product overview
Disposal
The packaging material is recyclable. Dispose of the
packaging in an environmentally-friendly manner and
make it available to the collection service for recyclable
materials. Dispose of the product in an environmental-
ly-friendly manner, too. For more information, contact
the administrative body in your community.
Z 09575_V0
All manuals and user guides at all-guides.com
Operating instructions
Product number Z 09575
1
1 Handle
2 Spray trigger
2
3 Upper pole
4 Lower pole
5 Cleaner tank
6 Spray head
7 Spray nozzle
3
8 Cleaning head with 4
cleaning clothes
4
5
6
7
8
Before fi rst use
Any water residue in the cleaner tank is due to the fact
that the product was tested after assembly and is not a
defect.
• Unpack all parts and remove all protective foils and stickers.
Check the product contents for any damages from transport.
Should you identify any transport damages, do not use the
product (!), instead please promptly consult the customer ser-
vice.
• Assemble the mop by fi rst inserting the upper pole (3) into the
bottom pole (4) until it audibly locks into place and then insert
the upper pole into the pole receptacle on the spray head (6)
until it audibly locks into place. Your mop is now ready for use!
Use
ATTENTION!
❐ When cleaning laminate fl oors, make sure that you do not
spray too much liquid cleaner on the fl oor. Otherwise it could
cause it to swell up!
1. Open the cleaner tank (5) by screwing its lid off.
2. Fill the cleaner tank with water or a cleaner of your choice.
3. Screw the lid back onto the cleaner tank.
4. Insert the cleaner tank into the receptacle on the spray head
(6).
5. Affi x the cleaning cloth to the cleaning head (8) with the Vel-
cro strap.
6. Now mop your fl oors as usual by moving the cleaning head
across the area you wish to clean and pressing the spray
trigger as needed to dampen the fl oor using the spray nozzle.
7. Fill the cleaner tank if it is empty and, if necessary, wash the
cleaning cloth out with hot water in between.
8. Always empty the container completely after use! Always
check the container before stowing it.
Cleaning and storage
ATTENTION!
❐ Do not use any scouring or abrasive cleaners or cleaning
pads for cleaning.
❐ Only air dry the cleaning cloth; do not in any case machine
dry it or dry it with a hair dryer!
• Clean the mop with a damp cloth and mild cleaner as needed.
• You can wash the cleaning cloth in the washing machine. Do
not use any softener as it may reduce the suction power
of the cleaning cloth! Make sure you follow the instruc-
tions on the cleaning cloth's washing label. Then let the
cleaning cloth air dry.
Customer service / importer:
DS Produkte GmbH, Am Heisterbusch 1, 19258 Gallin, Germany
Tel.: +49 (0) 38851 314650 *)
*) Calls subject to a charge.
All rights reserved.