Thrane & Thrane Explorer 300 Mise En Route page 9

BLUETOOTH PAIRING
NOTE: This section only describes how to pair devices in which you can enter a
passkey. For information on devices in which you cannot enter a passkey, such as
headsets, refer to the User Manual.
To pair a Bluetooth device, do as follows:
1. Start up the EXPLORER 300 as described in the beginning of this document.
2. Place your Bluetooth device close to the EXPLORER 300.
3. On your Bluetooth device, search for new devices and select the EXPLORER 300
when it is found.
The default Bluetooth name of the EXPLORER 300 is EXPLORER 300.
If there is more than one EXPLORER 300 in the list, you can use the MAC address
to locate the correct one. To see the MAC address of your EXPLORER 300, enter
the display menu system and select
PROPERTIES > TERMINAL > HARDWARE > MAC.
4. On your Bluetooth device, enter the passkey of your EXPLORER 300.
The default passkey is the serial number of your EXPLORER 300.
To see the serial number, look at the label on the back of the EXPLORER 300 or
enter the display menu system and select
PROPERTIES > TERMINAL > HARDWARE > UNIT SER. NO.
The new Bluetooth device is now paired and ready to communicate with the
EXPLORER 300.
NOTE: Maximum 2 devices can be paired with the EXPLORER 300. If you have
already paired 2 devices you have to unpair a device before you can pair a new
one. For information on how to unpair devices, refer to the User Manual.
All manuals and user guides at all-guides.com
GB