Thrane & Thrane Explorer 300 Mise En Route page 8

All manuals and user guides at all-guides.com
MAKING A BLUETOOTH DATA CONNECTION
To make a Bluetooth connection, place the computer close to the EXPLORER 300
and start up the EXPLORER 300 as described in the beginning of this document.
If the computer is already paired with the EXPLORER 300, the connection is
established automatically when both devices are ready and have discovered each
other. Note, however, that if your Bluetooth connection is defined as a dial-up
connection, you have to open the dial-up connection to activate the connection.
You are now ready to browse the Internet, check e-mails, send files etc.
NOTE: For information on configuration, refer to the User Manual. For information
on Bluetooth pairing, refer to the next section.