Thrane & Thrane Explorer 300 Mise En Route page 4

Connect the cables
3
Connect the cables to the relevant
connectors on the EXPLORER 300.
The connector panel is located on the side
of the EXPLORER 300.
One connector, the Bluetooth phone charging connector marked DC OUT, is
placed at the back of the EXPLORER 300.
Switch on the EXPLORER
4
Push the power button next to the display and hold it for 1-2 seconds until
the green power indicator lights up.
Enter the PIN
5
a. When you are asked for a PIN, press OK.
b. Press  or  a number of times until the
first digit is correct.
c. Press OK to go to the next digit.
The previous digit is indicated by a *.
d. After pressing OK to enter the last digit, press OK again to apply the PIN.
e. If you want to turn off the pointing sound, press  or  .
Point the antenna
6
Important! To obtain optimum bandwidth and operating time, adjust the
position of the antenna with great precision. Do not adjust the antenna
position until all cables are connected and the PIN entered.
All manuals and user guides at all-guides.com
300
®
Phone LAN Power