Fastening The Posts In The Intersections Of The Safety Perimeterç; Assembling The Access Gate - Astralpool NF P90-306 Manuel D'installation Et De L'utilisateur

TOP MODEL SAFETY FENCE
5.3. Once the panel is in position, place the upper
section using the panel itself as a guide and screw
it with the DIN-84 M4x20 screws to the M4 drill
holes in the posts.
5.4 Finally place the top trim cap.
6. FASTENING THE POSTS IN THE
INTERSECTIONS OF THE SAFETY PERI-
METER
NOTE: that the assembly of the posts positio-
ned in the intersections of the perimeter
(always at 90º) is the same as the rest of the
posts, but with the difference that these are
provided with drill holes at 90º instead of 180º
like the remaining posts.
Completing the safety perimeter of the pool
To complete the assembly of the safety fence,
repeat the process described in the previous points
until the safety perimeter of the pool is completed.
Leave one length of the safety perimeter free, where
no section should be assembled. This is where the
access gate to the pool will be assembled.

7. ASSEMBLING THE ACCESS GATE

The access gate to the pool will be assembled in
the length we have left free, following the instruc-
tions given below:
7.1. Screw the bracket angle of the gate frame onto
the lower part of one of the posts using DIN-7991
M4x10 screws, leaving the Ø10 axis facing
upwards, using a Allen spanner.
7.2. Insert the gate guide bushing until it reaches
the angle.
The next step is to position the gate frame. Two
people will be needed for this process to be able to
align and bolt the gate properly.
7.3. Place the guide bushing in the axis of the other
bracket angle and insert it in the drill hole on the
gate frame.
7.4. Hold the frame at both sides and insert the
lower angle axis in the drill hole in the frame.
MEDIUM MODEL SAFETY FENCE
7.5. Once the lower part of the frame has been
positioned, place it as far as possible in a vertical
position, trying out the gate to screw the bracket
support to the post using DIN-7991 M6x16 screws,
and on the lower part with a Allen spanner.
7.6. Fasten the gate lock to the free post. Place
the lock on the post and align the lock drill holes
with the M5 holes on the post. The lock is fastened
with the DIN-7991 M5x16 screws supplied.
7.7. Place the two fastening squares of the lock
and fasten them (see drawing....) using the DIN-
7991 M4x16 screws to the section itself and to the
previously installed bands.
7.8. You can now install the magnetic lock by sli-
ding it along the rails of the installed squares until
the lower part of the lock is aligned with the lower
part of the square.
7.9. Fasten screw DIN-7982 to one of the holes on
the lower part of the lock to ensure that it is fully
fastened.
7.10. Finally screw the support of the lock to the
door frame, using the DIN-7991 M5x16 screws, in
the drill holes of the frame. (see figure....)
Two movements are required unlock the safety
lock: lift the upper handle of the lock and once it
has unlocked, move the gate until it is released
from the lock without letting go of the upper handle.
Once the lock is open, the handle can be released.
To lock the gate, turn the gate until it aligns with the
lock fastened on the post.
NOTE: to adjust the frame with the door, see
the instructions of the magnetic lock.
ENGLISH
INSTALLATION
MANUAL
6