Panasonic JS-960WP Serie Mode D'emploi page 23

(5) Place the new display unit on a flat surface, hold the main unit with both hands, and
place the main unit so that the edges of the main unit IO panel are aligned within the
two positioning lines on the display unit. Then, slide the main unit slowly towards the
top side of the display unit to connect the connector of the main unit and the connector
of the display unit.
p Do not press the rear surface of the display unit. (Doing so may damage the
functionality of the LCD or touch panel.)
(6) Tighten the two thumbscrews of the main unit by hand to secure the display unit, and
close the thumbscrew covers of the main unit.
p Be sure to use hand when tightening the thumbscrews.
p Make sure that no looseness is detected when trying to move the display unit.
(7) Return the cable cover to its original position, and close the cable cover.
Edge of IO panel
(5)-1
Positioning lines
(6)-2
JS-960WP.indb 23
(5)-2
(7)
(6)-1
2012/02/15
23
15:19:35