Publicité
Les langues disponibles
Les langues disponibles
Precautions for Use
Attention for capacitive touch screen
p p Do not touch it by finger nail, because capacitive touch screen can not recognize it.
Touch it by finger tip.
p p Do not touch it during startup. It initializes touch screen during startup. If it is touched
during startup, touch screen is not initialized correctly.
p p Be careful to not accidentally touch around display edges or press on display bezel as it
can negatively affect display touch sensor accuracy.
p p Touch screen calibration can be affected by atmospheric change. In case of calibration
shifted, perform a calibration adjustment.
p p Adequacy of touch screen reaction-time or sensitivity may vary by operator. Display
sensitivity can be adjusted by executing a display sensitivity adjustment program.*
p p Capacitive touch-screen panel uses radio frequency to detect finger tip touch. Terminals
are configured to use different frequencies to avoid conflict in the event of two or more
terminals operating within 1.5 m (approx. 5 inches) of each other. In the event of conflict
('ghost' or inexplicable touch-screen reaction(s)), shutdown and reboot the terminal to
reselect touch screen frequency.
* Inquire to the supplier about the display sensitivity adjustment program.
Carrying/moving terminals
p p Do not lift or carry the terminal by holding the cable cover. Lift and carry the terminal by
securely holding the main unit from the bottom, with two hands.
Procure fixing screws separately.
p p The screws that secure this product are not supplied. Prepare them according to the
material and strength of the area where the product is to be installed.
Screw tightening
p p The screws and bolts must be tightened with an appropriate tightening torque according
to the material and strength of the installation area.
p p Do not use an impact driver. Use of an impact driver may damage the screws or cause
tightening excessively.
p p When a screw is tightened, make the screw at a right angle to the surface. After
tightening the screws or bolts, perform visual check to ensure tightening is enough and
there is no backlash.
Be sure to remove this product if it is not in use.
JS-960WP.indb
15
15
2012/02/15
15:19:22
Publicité
