Publicité
User and installation manual WE 14
7. Use of the Contactor box
Contactor box 2005-14 (WE – 14) can be used with the following sauna heaters:
- SKLE - ....
- SKLA - ....
- SKLF - ....
The control centre for contactor box WE 14 is 1601-28 (T2).
Refer to the T2 control panel operating manual for more specific instructions.
The contactor box is intended to be installed outside the sauna
installation. A connection box must be installed in the sauna room with a semi-fixed installation on the sauna heater.
Failure to follow the minimum clearances in the installation instructions may cause a fire hazard.
Always check the sauna room before switching the sauna heater on.
8. Locating the connecting box for the connection cable in the sauna room
A
Figure 4. Location for the connection box
Locating the connecting box for the connection cable in
the sauna room.
A = Specified minimum safety clearance, see table 1 or 2
1. Recommended location for the connecting box
2. Silumin box recommended in this area.
3. This area should be avoided. Always use a silumin box.
In other areas, use a heat-resisting box (T 125 °C) and heat-resisting cables (T 170 °C). The
connection box must be clear of obstacles. When installing the connection box to zones 2 or 3,
refer to the instructions and regulations of the local energy supplier.
All manuals and user guides at all-guides.com
1105 - ....
9 – 15 kW 230 V 3~ / 400 V – 415 V 3N~
1101 - ....
18 – 21 kW 230 V 3~, 18 – 26 kW 400 V – 415 V 3N~
1106 - ....
9 – 15 kW 400 V – 415 V 3N~
A
3.
2.
room.
The cables must be installed using a fixed
1.
7
Publicité
