Tasco 119422 Notice D'utilisation page 17

Parameter
Interval
Sensor Level Normal,
All manuals and user guides at all-guides.com
Description
Settings
(Bold=default)
10S Selects the length of time that the
camera will "wait" until it responds to
(second)
any additional triggers from the PIR
default,
with a 60M after an animal is first detected and
remains within the sensor's range.
(minute)
During this user set "ignore triggers"
to1S
(second) interval, the camera will not capture
photos/videos. This prevents the card
range of
from filling up with too many redundant
settings
available. images. Settings begin with 10 second
default when parameter is first selected.
Note: after setting down past "1S", settings
(60M-1M
start over at "60M".
are set in
one minute
increments,
59S-1S
are set in
one second
increments)
Selects the sensitivity of the PIR
sensor. The "High" setting will make
Low, High
the camera more sensitive to infrared
(heat) and more easily triggered by
motion, and the "Low" setting makes it
less sensitive to heat and motion. The
High setting can be useful when the
ambient temperature is warm (making
it more difficult for the sensor to detect
animals), and the Low setting may help
in cold weather if the camera is being
triggered too often by anything warmer
than the surroundings.
17