afriso CosiTherm FT Notice Technique page 38

6 Commissioning
6.1 Connecting the product to a controller module
The procedure (with EnOcean wireless) is described in the operating instruc-
tions of the "Controller module (wireless)".
 Verify that the EnOcean wireless signal of the product reaches the room
temperature sensor to be connected and that the room temperature sen-
sor is in the vicinity of the controller module.
6.2 Function test
Room temperature sensor "FT / FTF"
 Verify that the room temperature is between 15 °C and 25 °C.
1. Set the product to be tested to frost protection.
2. Set the product to be tested to 30 °C.
- After no more than one minute, the yellow LED lights up at the controller
module to which the product is connected.
3. Verify that the product to be tested is connected to the correct control cir-
cuit.
4. Repeat this procedure for all other products.
Commissioning
1. Press the LRN key of the
product with a bent open
paper clip for at least
0.5 seconds.
FT / FTF
EN
15