Bremont ALT1-WT Manuel D'instructions page 5

ALT1-WT
AUTOMATIC CHRONOMETER
Your Bremont watch shows you the time in hours, minutes and seconds, and
the date. With the chronograph you can measure up to 12 hours in hours,
seconds and minutes. It also shows the time in another time zone using
its 24 hour hand (or UTC hand). The mechanical movement with automatic
winding has a free-swinging rotor that keeps the mainspring wound via the
motion of your wrist. The movement in your ALT1-WT has 25 jewels, runs at
28,800 bph and has a 42-hour power reserve once fully wound. The watch
is water resistant to 100m (10ATM) and the dial is protected by a dual anti-
reflective sapphire crystal that is retained securely in the case.
To ensure that this rather special watch continues to run beautifully for
years to come you must follow a few important operating instructions...
WINdING THE WATCH
Your ALT1-WT can be wound from crown position I by rotating the crown
in a clockwise motion. The movement will automatically start with just a
few revolutions of the rotor, however it is better to wind the movement
fully with 30-40 revolutions of the crown. By doing this you will achieve
maximum accuracy and have a power reserve of 42-hours, even when the
watch is not on your wrist.
All manuals and user guides at all-guides.com
SETTING THE dATE
You can adjust the date by pulling out the crown to position II. You will
now be able to change the date by rotating the crown clockwise.
Do not change the date between 20:00 and 03:00
SETTING THE TIME
Pull the crown out to position III, this will stop the movement, you can
now position the minute hand exactly. To start the second hand, push the
crown back to position I. When setting the time, it is worth noting that
the date change always takes place at mid-night (00:00). If this change has
already taken place at 12:00 noon, you must move the hands forward by 12
hours. Ensure that the crown is pushed back in after setting the watch.
USING THE ROTO-CLICk® BEzEL
Your ALT1-WT is fitted with an internally rotating Roto-Click® bezel with
minute calibration. The bezel can be moved, both in a clockwise and
anti-clockwise direction using the bezel crown positioned at 8 o' c lock. To
use the timing function, rotate the bezel until the red triangle marker is
in line with the minute hand, the elapsed time can now be measured and
read using the minute hand against the minute and hour markers on the
dial ring