Save Operation; Econo Cool Operation - Mitsubishi Electric MSZ-EF18VE3W Notice D'utilisation

I-

SAVE OPERATION

• A simplifi ed set back function enables to recall the preferred (preset)
setting with a single push of the
and you can go back to the previous setting in an instance.
• i-save operation cannot be set on the weekly timer.
1
Press during COOL, ECONO COOL, or HEAT
mode to select i-save mode.
2
Set the temperature, fan speed, and airfl ow direction.
• The same setting is selected from the next time by simply pressing
.
• Two settings can be saved. (One for COOL/ECONO COOL, one for
HEAT)
• Select the appropriate temperature, fan speed, and airflow direction
according to your room.
• Normally, the minimum temperature setting in HEAT mode is 16°C.
However, during i-save operation only, the minimum temperature set-
ting is 10°C.
Press again to cancel i-save operation.
• i-save operation also is cancelled when the MODE button is pressed.
Note:
Example of use:
1. Low energy mode
Set the temperature 2°C to 3°C warmer in COOL and cooler in HEAT mode.
This setting is suitable for unoccupied room, and while you are sleeping.
2. Saving frequently used settings
Save your preferred setting for COOL/ECONO COOL and HEAT. This ena-
bles you to select your preferred setting with a single push of the button.
Note:
When using the multi system MXZ-8A140, the temperature cannot be set to
10°C. Even if the temperature is set to 10°C, the air conditioner will operate
at 16°C.
button. Press the button again
E
CONO COOL OPERATION
Swing airfl ow (change of air fl ow) makes you feel cooler than stationary
airfl ow. The set temperature and the airfl ow direction are automatically
changed by the microprocessor. It is possible to perform cooling opera-
tion with keeping comfort. As a result energy can be saved.
Press during COOL mode

ECONO COOL operation.

The unit performs swing operation vertically in various cycles according to the
temperature airflow.
Press again to cancel ECONO COOL operation.
• ECONO COOL operation is also cancelled when the VANE button is
pressed.
T
IMER OPERATION (ON/OFF TIMER)
1
Press or during operation to set the timer.
(ON timer) : The unit turns ON at the set time.
(OFF timer) : The unit turns OFF at the set time.
* or blinks.
* Make sure that the current time and day are set correctly.
2
Press (Increase) and
time of timer.
Each press increases or decreases the set time by 10 minutes.
• Set the timer while or
3
Press or again to cancel timer.
Note:
• ON and OFF timers can be set together.
operations.
• If power failure occurs while ON/OFF timer is set, see
function".
page 6 to start
Page 5
(Decrease) to set the
is blinking.
mark indicates the order of timer
page 10 "Auto restart
En-8