Télécharger Imprimer la page

Kärcher HD 600 Mode D'emploi page 15

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19
 Set nozzle to "CHEM".
or
Replace the high-pressure nozzle with
the low-pressure nozzle.
 Take out detergent suck hose.
 Set the detergent dosing valve in the fil-
ter to the central position; adjust the
dosing according to requirement using
+ or -.
 Suspend end of suction hose in a con-
tainer filled with detergent.
Recommended cleaning method
 Spray the detergent sparingly on the
dry surface and allow it to react, but not
to dry.
 Spray off loosened dirt with the high-
pressure ray.
 After operations, dip the filter in clear
water. Turn the dosing valve to the
highest detergent concentration. Start
the appliance and rinse for one minute.
Interrupting operation
 Close the hand spray gun.
The appliance switches off.
 Secure the trigger gun. To do so, push
the safety catch towards the front.
After the interruption:
 Release the trigger gun. To do so, push
the safety catch towards the back.
 Open the hand spray gun.
The appliance will switch on again.
Turn off the appliance
 Shut off water supply.
 Open the hand spray gun.
 Switch on the pump with the power
switch and allow to run for about 5-10
seconds.
 Close the hand spray gun.
 Set the appliance switch to "0/OFF".
 Pull main plug out of socket with dry
hands only.
 Remove water connection.
 Activate hand spray gun until device is
pressure less.
 Secure the trigger gun. To do so, push
the safety catch towards the front.
Frost protection
ATTENTION
Frost will destroy the not completely water
drained device.
Store the appliance in a frost free area.
If you cannot store it in a frost-free
place:
 Drain water.
 Pump in conventional frost protection
agents through the appliance.
Note:
Use normal glycol-based anti-freezing
agents for automobiles.
Observe handling instructions of the anti-
freeze agent manufacturer.
 Operate device for max. 1 minute until
the pump and conduits are empty.
CAUTION
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
ATTENTION
Protect the trigger from damage during
transport.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
CAUTION
Risk of injury and damage! Note the weight
of the appliance in case of storage.
Care and maintenance
DANGER
Risk of injury by inadvertent startup of ap-
pliance and electrical shock.
First pull out the plug from the mains before
carrying out any tasks on the machine.
Note:
Used oil must only be disposed of by the
designated collection points. Please turn in
used oil there. Polluting the environment
with used oil is prosecutable.
– 5
EN
Transport
Storage
15

Publicité

loading

Ce manuel est également adapté pour:

Hd 715