Operation - EuroLite LED Flexilight Mode D'emploi

and is installed in a distance of 0.5 meters between smoke machine and device. The room must only be
saturated with an amount of smoke that the visibility will always be more than 10 meters.
The ambient temperature must always be between -5° C and +45° C. Keep away from direct insulation
(particularly in cars) and heaters.
The relative humidity must not exceed 50 % with an ambient temperature of 45° C.
This device must only be operated in an altitude between -20 and 2000 m over NN.
Never use the device during thunderstorms. Over voltage could destroy the device. Always disconnect the
device during thunderstorms.
- - -m
The symbol determines the minimum distance from lighted objects. The minimum distance
between light-output and the illuminated surface must be more than 0.1 meters.
The housing must never touch surrounding surfaces or objects.
The maximum ambient temperature T = 45° C must never be exceeded.
a
Operate the device only after having become familiar with its functions. Do not permit operation by persons
not qualified for operating the device. Most damages are the result of unprofessional operation!
Never use solvents or aggressive detergents in order to clean the device! Rather use a soft and damp cloth.
Please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, etc.

OPERATION

For all devices with batteries:
Open the battery cover.
If replacing the batteries, remove the old batteries from the battery compartment. Only replace complete
battery-sets.
Caution!
Danger of explosion when battery is replaced improperly.
Only replace by the same type or similar types recommended by the manufacturer.
Remove empty batteries in accordance with the instructions of the manufacturer.
Insert the batteries (3 x 1.5 V Mignon batteries, AA) and make sure that the poles are correct.
Close the battery cover.
For all devices with power-unit:
Install the device at the desired installation spot. Connect the connection cable of the power-unit with the DC
IN-socket. Plug the power unit into your outlet. Via the rotary control, you can turn the lamp on and adjust the
dimmer intensity.
9/18 LED_FLEXILIGHTS_V_1_1.DOC