Videotec HTV Manuel D'instructions page 13

Open the housing as described in the relative chapter
(6.1 Housing opening, page 7).
Fix the support bracket (02) using the screw (01).
Place the power supply (03) on the support bracket.
Secure it all with the screws (04) and the corner fixing
bracket (5).
05
03
02
Fig. 8
Plug the multipolar female connector into the
corresponding male connector (J7, 6.3 Board
description, page 8).
Fig. 9
MNVCHTV32_2104_EN
04
01
7.3 Blower
7.3.1 Blower installation
Not usable in versions with double filter for
air renewal and wiper.
Pay attention to the voltage used to power
the circuit. Depending on requirements use
the correct power supply kit.
The blower kit should be assembled
according to the instructions to ensure a
correct air circulation inside the housing.
Open the housing as described in the relative chapter
(6.1 Housing opening, page 7).
Fix the blower using the corner bracket and screws.
Fig. 10
Plug the multipolar female connector into the
corresponding male connector (J8, 6.3 Board
description, page 8).
11