Roll Heads Maintenance - LPG wellbox S Guide D'installation Et D'utilisation

GB
roll heads
For reasons of hygiene, the treatment heads must be cleaned regularly
before and after every use, with the heads disconnected, using the supplied
wipes or wipes soaked with an antiseptic, bactericidal and fungicidal solution.
To clean the Roll heads
1 . Hold the head by the roller side.
Remove the rollers by pushing them out.
2 . Remove the seal from treatment chamber.
3 . Carefully clean the treatment chamber, the seal
and the rollers with a wipe.
4 . Put the seal back in place.
5 . Push the rollers back in until you hear a "click".
To clean the Roll head
1 . Holding the head in one hand, unclip the
protective parts from each of the rollers
and clean them using a wipe.
2 . Remove the two seals by delicately
removing them from their groove and then
clean them carefully using a wipe.
3 . Clean the treatment chamber and the rollers
with a wipe.
4 . Clip the protective parts to the forked seals
and place both parts into the head. Apply
slight pressure to the grooves to put everything
into place.
maintenance
1.
3.
4.
1.
2.
4.
16
M I N C E U R & A N T I - Â G E
2.
3.
5.
1.
3.