Starting-Up - LPG wellbox S Guide D'installation Et D'utilisation

GB
starting up
Before using your Wellbox, we recommend reading the installation
instructions.
1. After connecting the power (see page 14), press the
device. The control panel lights up. Before starting the treatment and
according to the instructions in this Installation and User Guide, you must select:
When you use the machine for the first time, all parameters are set at the lowest
values:
- Minimum intensity at
- Suction mode on Continuous
/ /
- Time at 6'
2. Select the head to use and then adjust the power settings, continuous or
rhythmic program, and duration by referring to the Instructional poster.
3. Press
start
stop
moving forward when the treatment begins. A lit arrow indicates the head's
moving direction. Press the trigger to reverse the direction. The lit arrow will also
change (see page 11).
4. You can interrupt the treatment at any time and resume when you want by
pressing
start
stop
5. To close your Wellbox after use:
- Connect the Roll head
- Roll the hose into the tube designed for this purpose (two times around).
- Place the Roll head
heads in their location in the top lid.
Your Wellbox automatically turns off after five minutes of non-use
• The intensity (Power)
• The treatment continuous or rhythmic program (Select)
• The duration of treatment (Time)
. Press on
(low/medium/high).
. Press or
06'00
to start the treatment. If the Roll head
.
to the hose.
in the location next to the control panel. Store the other
to increase
. Press on to switch to rhythmic mode
to select the required duration for treatment.
is connected, the rollers are
14
M I N C E U R & A N T I - Â G E
key to turn on the