Important Safety Information - LPG wellbox S Guide D'installation Et D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
GB

important safety information

Before any installation and use, it is greatly advised to read instructions
presented in this chapter.
DANGER : To reduce the risk of electric shock :
• Check that the voltage is consistent with the range indicated for the unit's power
(100-240 VAC). It must be connected to a wall outlet in accordance with your
country's specific standards. Avoid connecting your Wellbox on multiple socket
outlets. After each use and before cleaning, unplug your Wellbox's from the outlet.
• Do not use the Wellbox while taking a bath or shower. Do not place the Wellbox on
a wet or unstable surface or near a bathtub, shower, or sink. Use the Wellbox in
a dry location. Avoid allowing any water to splash into your Wellbox. Do not touch
a device that has fallen into the water. Immediately disconnect the power. Do not
allow the hose to pass through water. Do not use the Wellbox outdoors.
• Do not drop or insert objects in the openings of the device. Do not allow any solid
object or liquid to be sucked into the Wellbox.
WARNING : To reduce the risk of burns, fire, electric stock, or injury :
• Do not use the device under a blanket or similar item. Excessive heat can occur and
cause fire, electric shock, or injury to persons.
• Never use the device if it has a damaged cable or plug, if it does not work properly, if
it has been dropped or damaged, or if it has fallen into water. In these cases, please
contact LPG
• Do not carry or move the device by its top cover, cables, or hose, or use it as a
handle for transport. Do not drop the Wellbox. Do not shake or strike the unit.
• Do not use the Wellbox without having first connected the hoses to the heads.
Keep cables and hoses far from sources of heat. Do not use the device when the
temperature of the room is above 40°C.
• Do not use the device after using aerosol (spray) products or when oxygen is being
administered.
• The device should not be left unattended while plugged in. To turn off the device,
press the on/off button and then disconnect the AC/DC power from the outlet.
• Do not open or disassemble the device.
Customer Service.
®
4
M I N C E U R & A N T I - Â G E

Publicité

Table des Matières
loading

Table des Matières