Uline Metro Serie Instructions D'assemblage page 2

2. Align holes on end of support bar (3) with top of leg
frame. Insert three M6 x 15 mm bolts (E) and tighten.
Connect the second support bar to the same leg
frame next. Repeat for the opposite ends of the
support bars and second leg frame. (See Figure 2)
Figure 2
3. Place tabletop (1) upside down. Align leg frame
connector (A) with holes on end of tabletop. Insert
four M6 x 15 mm bolts (E) and tighten. Repeat for the
opposite end of the tabletop. (See Figure 3)
Figure 3
PAGE 2 OF 6
ASSEMBLY CONTINUED
3
E
1
E
A
4. Using two people, carefully lift the tabletop over the
assembled frame. Insert two M6 x 55 mm bolts (D)
through the middle of the leg frames into the leg
frame connectors and tighten. Insert 10 M6 x 75 mm
bolts (C) through the support bars and ends of the
leg frames into the tabletop and tighten.
(See Figure 4)
Figure 4
Table is now completely assembled.
1-800-295-5510
uline.com
C D
Completed Assembly
C
1121 IH-9775