Publicité
39
PRE-INSTALL & SCREW
40
PRESS SUPER BOLTS STUDS
J
PRESS
A full surface contact between tape and substrate is important for good adhesion performance.
Contact is achieved by applying pressure. In practice a pressure between 40 and 50 N/cm² is usually
needed and an application temperature between 25 and 45 °C or 77 and 113 °F is also necessary.
During application, add-on parts and tapes must have the similar temperature.
DATE: 02.28.19
INSTALLATION SUPER BOLT
ATTENTION
FULL SURFACE CONTACT IS CRITICAL FOR GOOD
ADHESION PERFORMANCE. ALWAYS APPLY FIRM
PRESSURE WHEN MOUNTING ADD ON PARTS AND
SUPER BOLT STUDS
www.warn.com
NISSAN - NAVARRA 2014
INSTALLATION MANUAL
TAPES.
10 mm
40-50 N/cm
PG.
2
13
Publicité
