Siemens KF86F Série Notice D'utilisation page 38

Installation and connection
en
Align the horizontal gap between the doors:
Caution!
To avoid damage to the appliance, move the right-hand
door down if the door pillar at the top collides with the
housing.
Remove the contents of the doors, if present.
Note:
Open the door and drawer.
1.
Lift the door and insert a screwdriver into the door
2.
hinge from below.
38
Push up the adjustable part and turn through 60°
3.
until the desired position is reached.
– The door height can be set at 2 levels, adjusted
by 1/16" (1.5 mm) in each case. The higher level
is followed by the lower. The adjustable part
engages as soon as a position is reached.
– To move the door up, turn clockwise.
– To move the door down, turn anticlockwise.
To check the position, close the door and drawer
4.
and correct if necessary.