Publicité
Les langues disponibles
Les langues disponibles
SEVERE WARNING
WARNING
SIGNS FOR
INSTALLATION
• Do not install the
refrigerator in a damp
place or place where it
may come in contact
with water.
- Deteriorated insulation of
electrical parts may cause an
electric shock or fire.
• Do not place this refrigerator
in direct sunlight or expose to
the heat from stoves, room
heaters or other appliance.
• Do not plug several appliances
into the same multiple power
board.
The refrigerator should always
be plugged into its own
individual electrical which has
a voltage rating that matched
the rating plate.
- This provides the best
performance and also
prevents overloading house
wiring circuits, which could
cause a fire hazard from
overheated wires.
• If the wall socket is loose, do
not insert the power plug.
- There is a risk of electric
shock of fire.
• Do not use a cord that shows
04_ safety information
cracks or abrasion damage
along its length or at either
end.
• Do not bend the power cord
excessively or place heavy
articles on it.
• Do not use aerosols near the
refrigerator.
- Aerosols used near the
refrigerator may cause an
explosion or fire.
• This refrigerator must be
properly installed and
located in accordance
with the manual before it
is used.
• Connect the power plug in
proper position with the cord
hanging down.
- If you connect the power plug
upside down, wire can get cut
off and cause fire or electric
shock.
• Make sure that the power plug
is not squashed or damaged
by the back of the refrigerator.
• When moving the refrigerator,
be careful not to roll over or
damage the power cord.
- This constitutes a fire hazard.
• The appliance must be
positioned so that the plug is
accessible after installation.
Publicité
