Samsung RL52TEBPN Mode D'emploi page 14

REVERSING THE
REFRIGERATOR DOOR
Samsung recommends that reversing of
the door opening is only completed by
WARNING
Samsung approved Service providers. This
will be on a chargeable basis and at the
customers expense.
Any damage caused while attempting to
reverse the door opening is not covered
under the appliance manufactures
warranty. Any repairs requested due to
this circumstance will be completed on a
chargeable basis at the customers expense.
Required Tools
Not provided
Phillips Head Flat Head
Driver (+) Driver (-)
Not provided
3/16" Allen
11mm Wrench
Wrench
(for hinge
(for middle
shaft)
hinge)
1. Remove 4 screws on the Top cover of the
refrigerator.
Screw
Make sure your refrigerator is unplugged
WARNING
before handling electrical wires.
14_ setting up
2. Remove the Top cover. Make sure to disconnect
the wire underneath the Top cover.
CAUTION
3. Disconnect the wire and then remove 3 bolts on
the top of the refrigerator.
CAUTION
10mm Socket
Wrench
4. Remove the Fridge door from the Middle hinge
(for bolts)
by carefully lifting the door straight up.
Additional part
Top Left
Hinge Cover
(Underneath
the Top Cover)
CAUTION
5. Disassemble the Middle hinge by removing 2
bolts and a screw on the right side.
Remove the Freezer door from the Bottom hinge
by carefully lifting the door straight up.
CAUTION
Be careful not to damage the electrical wires
when removing the Top cover.
Make sure the Fridge door is closed fi rmly.
Fridge door is heavy, be careful not to injure
yourself when removing the Fridge door.
Middle hinge
Bottom hinge
Freezer door is heavy, be careful not to
injure yourself when removing the Freezer
door.
Middle hinge