OCEAN DRIVE E5 Manuel D'emploi page 97

11. ASSEMBLING THE E-SCOOTER
- After removing the e-scooter from the packaging and checking that everything is compliant with
what is indicated in paragraph "8", it is necessary to assemble the dismounted components.
a• Open the kickstand (2) and position the e-scooter on a flat surface.
b• Raise the handlebars stem (7).
c• Raise the locking lever (6) and push it against the handlebars stem (7) until a hooking "click"
is heard.
d• Insert the handlebars (9) on the handlebars bar (7). Use the Allen wrench (e) to tighten the
screws (d) on both sides. If you notice any vibration of the handlebars, check the screws of
the folding intersection (5); if necessary use the Allen wrench to lock the two screws.
e• Press the ON/OFF button (23) to check that the e-scooter is switched on correctly.
6
click !
km/h mph
23
7
7
9
7
2
EN
d
e
5
97