OCEAN DRIVE E5 Manuel D'emploi page 106

15. MAINTENANCE
EN
- In general, when you are cleaning the e-scooter, make sure it is switched off, that the battery
charge cable is disconnected and that the cap of the charge socket on the appliance is closed
(see paragraph "12" - step "e").
- To clean the e-scooter, use a soft and slightly damp cloth. If cleaning is more difficult than ex-
pected, it is advised to use a toothbrush and to add toothpaste to remove most tenacious dirt.
Remove the toothpaste and residues with a soft and slightly damp cloth.
DO NOT use alcohol, petrol or other solvents, corrosive chemical
products in order to avoid damaging the e-scooter both aesthetically
and in its internal structure.
DO NOT use high pressure guns to clean the e-scooter.
- When the e-scooter is not used, store it in a dry environment away from humidity.
- Do not store the e-scooter outdoors.
Excessive exposition to sun, heat or cold may damage the e-scooter and accelerate tires and
batteries wear.
15.1 - DISC BRAKE ADJUSTMENT
Do not touch the disc brake right after use of the e-scooter. Danger of
burns !
- If the brake is too tight, use the supplied Allen key to undo the locking screw, then release the brake
cable pressure. Shorten the cable and tighten the locking screw. If the brake is too loose, carry out the
opposite operation and extend the brake cable.
106