Télécharger Imprimer la page

Lifetime 60371 Instructions D'assemblage page 46

Publicité

SECTION 8 (CONTINUED) /
TOOLS AND PARTS REQUIRED /
8.4
• Attach a shelf support bracket (HDV) into the side wall at the same level the shelf braces were placed. Repeat for the
other shelf support bracket on the opposite side.
• Placez le support de l'étagère (HDV) dans le mur de côté à la même hauteur que vous avez placé les renforts de
l'étagère. Répétez pour le support de l'étagère de l'autre côté.
• Fije un soporte de estante (HDV) en la pared lateral al mismo nivel en el que se colocaron los soportes del estante.
Repita para el otro soporte de estante en el lado opuesto.
8.5
• Unfold the shelf before installing.
• Dépliez l'étagère avant l'installation.
• Despliegue el estante antes de instalar.
8.6
• Snap the short and long shelf support tubes (HDT and HDU) into the underside of the shelf. The long shelf support tube
should be put in place near the side labelled "Front".
• Clipsez les tubes d'appui long et court de l'étagère (HDT et HDU) sous l'étagère. Le tube d'appui long doit être mis en
place près du côté marqué « Devant ».
• Conecte a presión los tubos de soporte del estante corto y largo (HDT y HDU) en la parte inferior del estante. El tubo de
soporte largo del estante debería ponerse en su lugar cerca del lado etiquetado "Front".
SECTION 8 (SUITE)
/
OUTILS ET QUINCAILLERIE REQUIS
HDV
GJZ
HDU
SECCIÓN 8 (CONTINUACIÓN)
/
INSTRUMENTAL Y HERRAJE REQUERIDOS
GJZ (x4)
GJZ
GJZ
46
HDV
GJZ

Publicité

loading