Kasco marine 2400EAF Guide D'utilisation page 7

Note: Extra hardware may be included.
Tools & Supplies Needed:
A. Anchors or stakes for installing unit (2 or 3 de-
pending on unit)
B. 208-240V Electrical Supply near pond on a post
C. Two (or 3 depending on model) 30cm pieces of
2.54cm galvanized pipe for weighting ropes (optional)
D. 9/16"(14mm) & 7/16" (11mm) Nut Driver
E. 9/16" (14mm) & 7/16" (11mm) Socket
Adjustable crescent wrench
8400EAF & 3.1EAF Assembly
STEP ONE
Remove all contents from package and place on a
clean, fl at surface. Inspect the shipment for any dam-
ages. Make sure you have all the parts needed.
STEP TWO
Arrange the three Float Sections (Part B1) upright
(plug on bottom) so the overlap of one section aligns
with the next section and loosely push the three sec-
tions together to form a continuous ring.
Float up
STEP THREE
Position one Top Float Bracket (Part B2) so that the bolt
holes in the bracket align with the bolt holes in the two
adjoined fl oat sections and insert two 9" Black Coated
Bolts (Part B4) through the assembly. This may require
some minor repositioning of the fl oat sections as you push
the bolt all the way through. Do not force the bolt through.
Repeat for the remaining two joints.
All manuals and user guides at all-guides.com
STEP FOUR
Turn the assembly upside down and place the Bottom Float
Brackets (Part B3) over the bolts, the ends of which should
now be extending through the assembly. Loosely install
the six Lock Nuts (Part B5) on the ends of the bolts (do not
tighten yet). Connect the top and bottom brackets using
three 1/4" x 3/4" Bolts (Part B7) with the three 1/4" Lock
Washers (Part B8) and 1/4" Nuts (Part B12) and tighten us-
ing the 7/16" (11mm) wrench and socket.
STEP FIVE
Return the assembly to the upside down position and place
the motor assembly (Stainless Steel can side up, black
pump down) in the center of the fl oat. Attach the motor to
the fl oat using the Unit Mounting Brackets (Part B6). The
notch in the center of the Unit Mounting Brackets should
be positioned over the top ring of the cage and should be
attached to the fl oat bracket using the two lowest holes of
the fl oat bracket.
Tighten using the 1/4" x 3/4" Bolts with 1/4" Lock Washers
using the 7/16" socket and wrench. (See pictures) Note:
If you have trouble positioning the Unit Mounting Bracket
between the Cage and Fountain Housing, you can use a
screwdriver to gently pry open enough space.
Float down
(plug)
STEP SEVEN
(Optional Bottom Screen: purchased separately)
Position the Bottom Screen (Part B10) over the fl oat
so the motor housing (can) passes through the large
hole in the center of the screen. Remove the center
three Lock Nuts from the 9" Bolts and place the Bot-
tom Screen Clips (Part B11) over the bolts as shown.
The power cord can be slid under the bottom screen
where two fl oat sections come together before the
Lock Nuts are replaced. Replace the three inside Lock
Nuts and tighten all 3/8" Lock Nuts using the 9/16"
(14mm) wrench and socket.
7