Kasco marine 2400EAF Guide D'utilisation page 6

Tighten until snug with a Phillips Head screw driver
and repeat for 3 remaining screws.
STEP FOUR
Turn secured assembly upside down so the top of the
fl oat (logo side) is face down on the fl at surface. Place
Bottom Screen (Part 10) onto the bottom side of the
fl oat. Make sure the wide opening of the screen is
against the fl oat and the 3 handles on the screen do not
interfere with the rope placements. Fit the 3 Bottom
Screen cushion (Part 9) underneath the screen and on
top of the 3 spacing bumps on the bottom of the fl oat.
Bottom Screen cushion
STEP FIVE
Using a stainless steel Bottom Screen Clip (Part 11),
3/8"-16 x 1-3/8" Bolt (Part 7), two 3/8" Flat Washer
(Part 8), and 3/8"-16 Nylon Lock Nut (Part 12) to
secure the screen to the fl oat. Align a clip so the two
prongs straddle a wire on the screen. Insert bolt with
washer so the top of the bolt is facing the top of fl oat
(now in down position). Place the second washer and
the locking nut with nylon insert on the end of the bolt
and tighten using the 9/16" (14mm) Socket and Ratch-
et on the nut end and the 9/16" (14mm) Wrench on the
bolt end. Tighten until snug and repeat with remaining
clip.
6
All manuals and user guides at all-guides.com
STEP SIX
Turn the assembly upright again. At this time, if the
cord contains a metal strain relief, you can use the
chain connector and attach it in one of the opening at
the rope placement. The chain connector will easily fi t
if installed from the bottom or top side of the opening.
It will not fi t if installed from side of opening. Use the
Nylon Cable Tie (Part I) included to secure the power
cord to a molded hole in the fl oat to prevent cord
damage if there is no strain relief on the cord. If a
Strain Relief is present on the cord, you may disregard
the Nylon Tie. On cords with a Quick Disconnect,
the disconnect should be tightened properly to avoid
leaking. If installing a new Quick Disconnect, refer to
Quick Disconnect Instructions. If ready to install in
the pond, go to Installation instructions.
B2. Large Float Ring
See Diagram below.
8400EAF & 3.1EAF Parts
1. Float Section (3)
2. Top Float Bracket (3)
3. Bottom Float Bracket w/Rope (3)
4. 9" x 3/8" Bolt (6)
5. 3/8" Lock Nut (6)
6. Unit Mounting Bracket
7. 1/4"x 3/4" Bolt
8. 1/4" Lock Washer
9. 1/4" Nut (3)
10. Bottom Screen (1 - optional)
11. Bottom Screen Clips (3 - optional)