Kasco marine 2400EAF Guide D'utilisation page 2

CAUTION
NOTICE (NOTE)
These international safety symbols are used through-
out this manual to inform the owner of important
safety information and notices for safe and effective
use of the equipment.
Important Safety Instructions
CAUTION
• Under NO circumstances should anyone enter
the water with the electrical equipment con-
nected and/or in operation. It is NEVER rec-
ommended to enter the water with the equip-
ment in operation.
• Caution should be used when dealing with any
electrical equipment with moving parts.
• NEVER run the unit out of water. It will dam-
age the seals and create a dangerous situation
for the operator.
• Extreme caution should be used around water,
especially cold water, such as in Spring, Fall,
and Winter, which poses a hazard in and of
itself.
• NEVER lift or drag the unit by the power or
light cord. If you need to pull the unit to the
side of the pond, use the anchoring ropes.
• Do not use waders in deep ponds/lakes or
ponds/lakes with drop-offs, drastic slopes, or
soft bottom material.
• Do not use boats that tip easily for fountain
installation, such as a canoe, and follow all
boating safety rules and regulations, including
wearing a PFD. (Personal Flotation Device)
• The unit is supplied with an internal ground-
ing conductor. To reduce the risk of electrical
shock, be certain that the unit is plugged/con-
nected to an approved RCD (GFCI) protected
circuit.
• Means for disconnection must be incorporated
in the fi xed wiring in accordance with local and
national wiring rules.
• Consult a qualifi ed electrician for electrical
installation.
2
All manuals and user guides at all-guides.com
Important – Read Carefully Before Installation
Before using the connector, it is important that these
instructions are carefully read and understood to
ensure the connector system is completely water tight
and electrically safe.
IF IN DOUBT CONSULT A QUALIFIED ELECTRI-
CIAN.
The socket (female) insert of the connector must be
the live part of the connector from the supply. The pin
(male) insert of the connector must lead to the load or
electrical device. On 50Hz units, the pin (male) insert
of the connector is installed at the factory. To ensure
effi cient sealing, use only smooth circular cable.
Pin Insert (Installed on Stub Cord)
Socket Insert (User Installed)
Socket insert
Unit Specs
Model Voltage Operating
2400EAF 208-240
3400EAF 208-240
4400EAF 208-240
8400EAF 208-240
3.1EAF 208-240
2400ECF 208-240
3400ECF 208-240
4400ECF 208-240
8400ECF 208-240
Quick Disconnect Installation
Main Body
Pin Insert
Main Body
lock rotor
amps amps
2.2@240V 6@240V
3.4@240V 9@240V
3.7@240V 20@240V
8.0@240V 40@240V
11.9@240V 60@240V
2.2@240V 6@240V
3.4@240V 9@240V
3.7@240V 20@240V
8.0@240V 40@240V
Gland
Gland Nut
Gland
Gland Nut