Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
6. Strap adjustment
Close the clip (see figure 3). Adjust the length of the chin strap by pulling
on the outer straps.
The chin strap should be close-fitting but not restrict breathing or swal-
lowing.
7. Extras
7.1 Lighting
The Quicksafe is equipped with flashing lamps. You can switch the light
on and off by pressing (see figure 6).
Battery change: use a narrow flat screwdriver to open the housing (see
figure 7), remove the board and replace the batteries.
8. Care, cleaning and storage
The comfortable padding can be cleaned with a moist cloth. A mild soapy
solution or diluted delicate washing powder can be used as a detergent.
The padding and straps should be dried at room temperature.
The shell of the helmet should be cleaned with lukewarm water and a
mild soapy solution. Do not use any solvents such as thinners or similar
products.
Excessively high temperatures or strong UV rays can damage your hel-
met. It should therefore not be stored in temperatures above 60° C, such
as on the back shelf of a car. Do not place it on or near to a source of
heat such as an oven. The helmet should simply be kept in a dry place.
The helmet should be checked for visible defects at regular intervals. Mi-
nor scratches do not affect your helmet's level of protection.
Only original parts should be used for repairs.
Please consult your dealer
9. Safe use
This helmet is only suitable for riding, cycling and roller skating. It is not
suitable for other sports such as motorcycling or riding a scooter or moped.
Check your helmet for a correct fit before setting off. The clip system on
the chin strap must be fully closed. The straps must be closely fitted.
Please check the helmets of any children accompanying you.
Do not draw or paint on the helmet and do not apply stickers. The inks,
paints and glues may contain components that have a negative influence
on the stability of your helmet and its protection level.
Do not make any alterations to the helmet shell. Do not drill into it or screw
on any objects.
10
Publicité
