Zipro One S Manuel D'utilisation page 13

EN
ADJUSTMENTS
Resistance adjustment
Saddle height
Adjusting pedal straps
Levelling
COMPUTER MANUAL
Remove the safety film from the display before use.
COMPUTER (MODEL)
MRMS01-BLU
AUTO ON/OFF
The computer is switched on when the flywheel moves or any button is pressed.
The display shows an up arrow.
The computer is switched off after four minutes of inactivity.
BUTTONS
MODE - selects the parameter.
SET - sets parameter values.
RESET - resets time, distance, and calories immediately.
FUNCTIONS (SPECIFICATION)
SCAN
TIME
SPEED
DISTANCE
CALORIES
TOTAL DISTANCE (ODO)
PULSE
13
In order to increase the resistance, turn the resistance knob clockwise. In order to decrease the resistance, turn the
resistance knob counterclockwise.
Loosen the adjustment knob. Set the saddle at the right height and tighten the knob. Make sure the saddle is secured.
Fix the side of the rubber strap with three holes to the internal part of the pedal. Fix the other end to one of the
adjustment opening so that the feet is fixed during training and easy to take out. Repeat for the other pedal.
Level the device by rotating the levelling pads on the rear base. The pads are polygons, and each side has a different
height. Find the right one to stabilise the device.
Displays all measured training parameters in a cycle.
Total exercise duration, from the start to the end.
Displays the current speed.
Total distance from the start to the end of the exercise.
Total calories burnt from the start to the end of the exercise.
(The measurement is an approximation for comparing training sessions. Do not use for
medical purposes).
Total distance from battery installation.
Displays the current heart rate.
5. Mount the right and left pedal
Put the securing strap on the left pedal (6L). It is marked with 'L'. Do the same
with the right pedal (6R).
Fix the pedals to the crank (54) on appropriate sides. Screw the right pedal
bolt (6R) on clockwise. Screw the left pedal bolt (6L) counterclockwise.
CAUTION! The right pedal is marked 'R' and the left pedal is marked 'L'. The
right pedal is on the right-hand side when sitting on the bicycle.
See how to complete this step.
Scan the QR code and watch the video.
every 4 seconds
00:00-99:59 min
0,0-99,9 km/h
0,0-9999 km
0,0-9999 kcal
0-9999 km
40-240 BPM