Elettro CF TIG 1680 Manuel D'instructions page 9

Pulse frequency (0.16 to 250 Hz).
The base and peak times are the same.
M LED
Second level of current in dual level mode.
N LED
Slope down. This is the time during which the current
reaches its minimum value and the arc is extinguished (0-10
sec.).
O LED
Post gas. Adjusts the gas flow time at the end of welding (0-
30 sec.).
P – Knob.
Adjusts the welding current – G LED.
In addition, combined with the I push-button, you may:
- adjust the "slope up" H
- adjust the base pulse current F
- adjust the pulse frequency L
- adjust the second level of current in dual level M
- adjust the "slope down" N
- adjust the post gas O
R LED – Welding machine block (see 2.3.2)
S LED – Thermal protection.
It lights w hen the operator exceeds the duty cycle o
p ercentage intermittence allowed for the machine and
simultaneously locks the current output.
N.B. Un der this condition the fan go
power source.
Q – Display
Displays the welding current and the settings which were
s elected via the I push-button and adjusted via the P knob.
W – Selector switch for programs in memory.
Selects and saves the programs in memory.
The welding machine can save nine welding programs
P01.....P09 and call them up via this button. A working
program PL is also available.
Selecting
When this push-button is pressed briefly, the Q display
shows the program number next to the one in use. If this has
not been saved, the message
steady.
Saving
Once the program has been selected, hold down for more
than 3 seconds to save the data in memory.
To confi rm this, the program number on the Q display will
stop flash ing
All manuals and user guides at all-guides.com
r
es on cooling the
will flash, otherwise it remains
Y – 10-PIN CONNECTOR.
T he following remote controls are to be connected to this
connector:
a) foot control
b) torch with start button
c) torch with potentiometer
d) torch with
up/down
e) remote contr ol, etc.
X – ¼ gas fitting.
T his is where the gas hose of the TIG welding torch is to
be connected.
A1
Negative output terminal (-)
A2
Positive output terminal (+)
A3 – Switch.
Turns the machine on and off.
A4 – Gas intake fitting.
A 5 – Power supply cable.
3.3. GENERAL NOTES
Before u sing this welding machine,
s tandards CEI 26/9 - CENELEC HD 407 and CEI 26.11 -
CENELEC HD 433. Also
c ables, electrode clamps, sockets and plugs are intact,
and that the size and length of the welding cables are
compatible with the current used.
3.4 MMA WELDING (MANUAL METAL ARC)
- This welding machine is suitable
el ectrodes, with the exception of cellulosic (AWS 6010)*.
- Make sure that the switch A3 is in position
c onnect the welding cables, observing the polarity
required by the manufacturer of the electrodes you will be
using; also connect the damp of the ground cable to the
workpiece, as close to the weld as possible, making sure
that there is good electrical contact.
- Do NOT touch the torch or electrode damp
simultaneously with the earth clamp.
-Turn the machine on using the switch A3.
- Select the MMA procedure by pre
LED A lit.
- Adjust the current based on th
electrode, the welding position and the type
made.
- Always rememb er to shut off the machine and
remove the electrode from the clamp after welding.
9
carefully read the
make sure the insulation of the
for welding all types of
0, then
ssing the button C:
e diameter of the
of joint to be