Publicité
Les langues disponibles
Les langues disponibles
Remove the product from the packaging, check all the
accessories are included and follow the instructions.
Step 1: Fully charge the battery. Connect the USB end of
the cable to the adapter then plug the adapter into a socket
(230 V ~50 Hz) and the end of the cable into the
micro USB port under the product (4). Unscrew the base to
make this easier if necessary.
Press
to turn the meter on. A 30-second countdown is
shown on the display for the device to warm up and adjust.
Important: Do not adjust settings or use the meter when it is
warming up.
The battery indicator (6) indicates the progress of charging.
The full charge time is 4 hours.
After shipping and removing the protective packaging, the
product must be placed in a well-ventilated area for a few
Importé par :
-37-
AIC International - 44980 Ste Luce sur Loire - France
minutes prior to setting and use so the sensors are clear
and ready for use.
Measurements are shown on the display when the count-
down is complete.
Step 2: Setting the alarm. To adapt to each user's needs
and environment, the Quaelis 10 CO2 meter allows you to
customise the CO2 concentration at which the alarm will be
triggered. This does not alter the measurement system.
The default setting for triggering the alarm is 2000 ppm.
Important: The current limits according to applicable
regulations and standards usually vary between 1000 and
1500 ppm. We recommend a maximum threshold of
2000 ppm for triggering the alarm. This does not alter the
measurement system and the measured values continue to
be shown on the display even when they are higher
than the value defined for the alarm.
Importé par :
AIC International - 44980 Ste Luce sur Loire - France
-38-
Publicité
