Pinnacle Climate Technologies PROTEMP PT-16-TTC Manuel De L'utilisateur Et Instructions D'utilisation page 7

Model PT-32-TTC:
Tools Needed:
– Medium Phillips head screwdriver.
1. Place the tank collar bracket on top of the
center plate. Be sure the mounting bolt knob is
on bottom as shown in Figure 4
2. Insert machine screw into top hole using
Phillips head screwdriver.
3. Insert 2nd machine screw into bottom hole.
This will secure the tank collar bracket to the
center plate.
DO NOT adjust burner heads while heater is operating.
WARNING
Tip over Switch
Assembly
Swivel
Manifold
Tank Collar Bracket
Figure 4
Missing Parts? Please Call 800-779-3267 For Assistance
© 2017, Pinnacle Climate Technologies, Inc.
®
Assembly
Machine
Screws
Regulator
Knob
Fuel Connector Nut
Mounting Bolt Knob
NEVER LEAVE HEATER UNATTENDED
WHILE BURNING OR WHILE CONNECTED
TO A FUEL SOURCE
Model PT-47-TTC:
Tools Needed:
– Medium Phillips head screwdriver.
1. Insert the mounting bolt knob into the tank
collar bracket.
2. Place tank collar bracket on the swivel bracket.
3. Place the plane washer on the tank collar
bracket and then insert the support bolt.
(See Figure 5)
4. See Figure 6 on page 7 for determining burner
position options.
Swivel Bracket
Regulator
Knob
Figure 5
Propane Tank Top Heater User's Manual
6
Plane Washer
Fuel Connector Nut Tank Collar Bracket
Wing Nut
Mounting
Bolt Knob