Operating; Vacuuming - Dirt Devil Maxima Mode D'emploi

3 Operating

1
A
B
3 Operating

3.1 Vacuuming

Proceed as follows to attach the nozzles:
1. Switch the appliance off and pull the plug out of the
socket.
2. Remove the exiting nozzle from the telescopic tube.
3. Push the desired nozzle on the lower end of the
telescopic tube or if necessary directly onto the handle
(Fig. 9).
Fig. 9
ATTENTION:
If you use the cylinder vacuum cleaner without attached
nozzles, there is a greater risk of accidently vacuuming
up objects.
4. As illustrated, secure the nozzles no longer required
onto the accessories mount, as far as this is possible.
- Push the 2-in-1 combi-nozzle into the accessories
mount (Fig. 10/A).
- Push the crevice nozzle onto the accessories mount
and attach it so it clicks audibly and noticeably into
place (Fig. 10/B).
5. Keep the other nozzles safe and inaccessible to
Fig. 10 children.
.
WARNING:
Check the cylinder vacuum cleaner and the power cable
before each use. A damaged appliance must never be
used. There is a risk of injury.
ATTENTION:
Only use the cylinder vacuum cleaner if all the filters are
intact, dry and inserted correctly. Make sure that none of
the openings are blocked. Otherwise, the vacuum
cleaner can become damaged.
NOTE:
Your cylinder vacuum cleaner has an overheating
protection device. It turns off automatically if it overheats.
If this happens, then turn off the cylinder vacuum cleaner
and remove the plug. Remove the cause of overheating.
Wait approx. 45 minutes. Once the cylinder vacuum
cleaner has cooled down you can switch it on again.
27