ROQUES LECOEUR RL1110 4WD Manuel D'utilisation Et D'entretien page 99

6.3.13 Replacing belts
Replacing drive belts is a relatively demanding operation, which needs to performed by an authorised service centre.
When attaching a new belt pay special attention when working with the machine because the belt is not
yet sufficiently run-in.
Type of belts used:
Mowing deck blade
Machine drive belt – from elmag.
GC 92 5L690 Roflex Garden
GC 110 5L650 Roflex Garden
GC 132 5L690 Roflex Garden
6.3.14 Replacing wheels
Before replacing one of the wheels, park the tractor on a horizontal and rigid surface, turn off the engine and remove the
key from the ignition. Secure the machine against movement. Do not replace the wheel if the machine is not sufficiently
secured in the elevated position!
If you do not have suitable tools or the necessary knowledge, contact your seller.
Perform the replacement as follows:
 Place the jack underneath the front or rear bumper near to the wheel which you wish
to replace. Always place the jack against the frame, do not lean it on the transmission
- risk of damaging it!
 Keep lifting the machine until the wheel, which you wish to change no longer touches
the ground.
 Remove the protective cover from the wheel.
 Using a suitable screwdriver remove the retaining ring and remove the washer.
 Pull the wheel off the shaft.
When reattaching the wheel proceed in the reverse sequence to its removal. Before attaching the wheel clean all
parts and lightly grease the shaft with a plastic lubricant. Especially for wheels on the rear axle this lubrication is
essential for the subsequent removal of the wheel. In the event that lubrication is not performed the subsequent
attachment may be very difficult.
When attaching the rear wheel pay attention to the mutual alignment of the pin on the shaft and the groove on the wheel.
Finally check the tyre pressure.
6.3.15 Repairing a tyre puncture
The machine is equipped with tubeless tyres. In the event of a puncture have it repaired at a specialised tyre repair shop
or at an authorised Seco machine service centre.
Mowing deck blade drive
belt – from main belt pulley
transmission
(none)
Continental 312 AA126
Right 13 x 1325Li A52
Left AA78 HAA-2032
99
Travel drive belt
X13x830 OPTIBELT