Publicité
Les langues disponibles
Les langues disponibles
(continued)
Malfunction, defect
The machine loses
power when travelling
up a hill
Extreme vibrations
occur when travelling
The steering is slipping
through or loose
The engine does not run
The engine is rotating
but will not start up
7.1 Ordering spare parts
We recommend that you use exclusively original spare parts, which ensure safety and compatibility. Always order spare
parts from an authorised distributor or service organisation, which is informed about the current technical changes
performed on the products during manufacture.
For easy, fast and exact identification of the necessary spare part always provide in your order the serial number found
on the second side of the cover of this publication. Also provide the year of manufacture as shown on the product
identification label under the seat.
7.2 Warranty
Warranty conditions are provided on the warranty card, which is always provided together with the product by the seller.
When the machine is under a high load and the ambient temperature is high, then the
maximum working temperature of the oil may be exceeded. Lower the work demands
on the machine.
Check whether any pulleys are damage or deformed. Replace them if necessary.
Check whether the belt has any burned spaces or other irregularities. Replace it if
necessary.
Check the tension of the travel drive belt (
Check that the mowing blades are balanced. Balance or replace them if necessary.
Check that the space between the pinion and the segment is not too large. If yes,
adjust the cogged segment. Check for wear on the ball and socket joints. Replace the
joints if necessary.
Check that there is petrol in the petrol tank.
Check that the prescribed procedure for starting the engine was followed
(
5.2)
Check the fuse. Replace if necessary.
Check whether the voltage on the battery terminals is 12 V. On a new machine check
whether the battery was activated and charged. On new machines replace the spark
plug and check that there is not oil accumulated on the cylinder due to incorrect
handling.
Check that all wire connections are in order and that the electrical system switches
work.
Check the engine again exactly according to the instructions in the User's manual
of the engine manufacturer. Have the electrical system checked at a specialised
workshop.
Check that the prescribed procedure for starting the engine was followed
(
5.2) Check that the petrol in the petrol tank is clean.
Check that the fuel filter is not clogged.
Make sure that the throttle lever is in the position "CHOKE".
Check the engine again exactly according to the instructions in the User's manual of
the engine manufacturer. Have the cabling and switches checked at a specialised
workshop.
104
Remedy
6.3.10). If necessary adjust its tension.
Publicité
