Publicité
Les langues disponibles
Les langues disponibles
UNDERMOUNT: STAINLESS STEEL
This sink is specifically designed to be undermounted in a solid surface countertop only.
CAUTION: Sink edge may be sharp; handle with caution. Do not install a damaged sink. Inspect carefully.
1. The size should be exact as this sink uses coordinating accessories which fit precisely in the cut out.
6
Countertop cut is top of bevel.
2. Determine placement of the clip brackets as indicated on the template. Pre-drill holes according to method desired based on
countertop material. NOTE: You the fabricator, may elect to epoxy in the screw or use a brass anchor.
3. Apply a bead of silicone evenly along edge on the underside of countertop.
4. Position and align sink over the opening. Press sink into silicone seal.
5. After re-checking alignment, tighten clip brackets against the sink edge.
6. Remove excess silicone.
HINT: After silicone cures, wipe inside edge with denatured alcohol. This will smooth out any rough areas.
NOTE: The template included (or .dxf file downloaded from website) is only a guide. The actual sink and accessories should ALWAYS
be present to ensure a perfect cut. FRANKE is not responsible for an improperly cut countertop or improper installation.
SINKS THAT CAN EITHER BE INSET or UNDERMOUNTED
NOTE: The sink template has been designed for both inset and undermounting. The template is standard for inset mounting.
If undermounting method is needed, simply remove the outer ring at the perforated score.
CAUTION: Damage caused by improper handling or installation is not covered by the warranty. Do not install a damaged sink.
7
1. Cut out countertop per cutout.
A. INSET
2A.
Apply silicone to underside of the rim.
3A.
Lower the sink into the countertop cutout. (Waste hole should be positioned at the rear).
4A.
Tighten the clip against the underside of the counter.
B. UNDERMOUNT
2B. Cut-out should be flush with the countertop.
3B. Determine placement of clip brackets as indicated by template. Pre-drill holes according to method desired based on
countertop material. NOTE: You the fabricator may elect to epoxy in the screw or use a brass anchor (not provided).
4B. Apply a bead of silicone evenly along wedge of underside of counter.
5B. Position and align sink over opening. Press sink into silicone seal.
6B. After re-checking alignment, tighten clip bracket against sink edge.
7B. Remove excess silicone.
NOTE: The template included (or .dxf file downloaded from website) is only a guide. The actual sink and accessories should ALWAYS
be present to ensure a perfect cut. FRANKE is not responsible for an improperly cut countertop or improper installation.
0714
No recessed countertop.
No countertop overhang.
FSII0714
Publicité
