Troubleshooting - Kettler Hybritec Manuel

Troubleshooting

Do not attempt to repair the electric drive system, control system or battery. For any necessary service or repair work, always contact your
KETTLER dealer who has the necessary information and expertise to carry out repairs.
Reset: Errors in the sensor torque measurement
In case of incorrect measurement by the torque sensor, the LEDs on the operating unit flash according to the following pattern:
Flashing LEDs
Two power diodes
All three mode diodes
To reset the sensor, remove any pressure from the pedals and switch the Power button off and then on again.
Failure of motor
In case of motor failure, the LEDs on the operating unit flash according to the following pattern:
Flashing LEDs
Two power diodes
All three mode diodes
To reset the motor, remove any pressure from the pedals and switch the Power button off and then on again.
14
All manuals and user guides at all-guides.com
Flash interval: one space equals 0.5 sec.
Should the error persist, take your Pedelec to a KETTLER dealer.
Flash interval: one space equals 0.5 sec.
Should the error persist, take your Pedelec to a KETTLER dealer.