Safety Instructions - Selve SE Pro Serie Notice De Réglage

Safety instructions

• Check the system at regular intervals for a lack of balance or for
signs of wear or damaged springs and connection cables. It
must not be used if repairs or corrections are required. Check
the motor and the complete installation for damage. In case of
damage to the motor, in particular to the connection line, it must
not be taken into operation!
• The motor is only working when installed and must only be
connected when powered down. The motor must only be
connected to the powered part with adapters and couplings
from the current SELVE catalogue. The smallest shaft diameter
for SELVE motors for series 1 (e.g. SE.. 1/...) is 40 mm, for series
2 (e.g. SE.. 2/...) 50 mm and for series 3 (e.g. SE.. 3/...) 60 mm.
For grooved tubes, there may be an eccentric design for the cou­
pling and adapter.
• Nominal torque and duration of activation must be aligned with
the system requirements. Technical data such as nominal torque
and duration of activation are written on the identification plate.
• If a motor is used in an awning, the awning must not be operated
while work such as maintenance or window cleaning is carried
out nearby. For automatically controlled awnings, the awning
must be disconnected from the power for the above work.
• The motor may be used by children aged 8 or over and by
people with reduced physical, sensory or mental abilities or with
a lack of experience and knowledge if they are supervised or
have been trained in how to use the device safely and they
understand the risks involved.
• Keep objects from the operating area. It must be possible to
see the operation area during working process. Observe the
system while it is operating and keep other people away from
it. Use only locked switching elements.
• On motors which are controlled using a switch with an OFF
setting, the switch must be fitted in view of the device, away
from moving parts and at a height of over 1.5 m.
21
EN
EN