EMAK K 2400 ADV V-TWIN Manuel D'utilisation Et D'entretien page 13

duct with a rag to prevent them from the
entering the engine.
f ) Remove the rag, install the filtering element
(C, Fig.4) in its housing and refit the cover (A).
6.6 SPARK PLUG SERVICE (FIG.6)
a) Remove the spark plug using a spark plug
socket wrench.
b) Clean the electrodes with a metal brush and
remove any carbonaceous build-up.
c) Using a thickness gauge, check for the right
gap (0.7-0.8mm) between the electrodes.
d) Install the spark plug and tighten with a socket
wrench.
Replace the spark plug if the electrodes are burnt
or if the porcelain is broken or damaged.
WARNING: Fire hazard! Do not check the
ignition system with spark plug removed.
IMPORTANT: Use only spark plugs of the
recommended type.
6.7 TUNING THE THROTTLE CABLE ANDTHE
CARBURETTOR
Should the engine not reach maximum revs with
the throttle trigger set to "FAST", it could be due to
the throttle trigger and speed control lever being
out of phase or to a carburetion problem.
Go to a Specialized Centre or contact your Dealer
to restore normal operation.
GB 13