General Safety Instructions - Renson HOBO 34L Série Manuel D'installation De Mise En Service Et D'utilisation

First, we wish to thank you for choosing our tank. We feel confident that thanks to its construction and the quality of
materials used, it will provide you with satisfactory performance.
The fuel dispensing unit installed on this tank can be used for the transfer of hydrocarbons as gasoil or fuel oil in agriculture,
construction, industry or any other sector where transfer of fuel is needed.
In order to optimize performances of your dispensing unit, we recommend that you read these carefully and that you follow
the instructions exactly.

1) General safety instructions

2) Installation of the tank
3) Servicing and cleaning
4) Maintenance
5) General safety instructions and use of the pump
6) Commissioning of the pump
7) Waste disposal and recycling
8) Trouble shooting
9) Notification of conformity
10) Notes
Read carefully
Maintenance and repair
Double attention to the safety pictures
Your HOBO is conceived to contain dangerous liquids of group III gasoil/fuel.
The tank you just acquired fits to the Dangerous Matierial transportation regulation (ADR). Its transportation and use must fit
to ADR also, this is the responsibility of the transporter.
During the transportation, the HOBO must be : Pump, valve and gun closed and must be equipped with caps and vents
provided. No exterior elements to the HOBO shall be stored into the overhead bins.
The HOBO contains identification and regulatory markings on the front. These must stay visible in case of control.
RENSON INTERNATIONAL society's responsibility will not be engaged in case of damages caused by the non-respect of given
instructions.
No guarantee will be due in case of modifications, interventions, repair or maintenance, as well as in case of any other
problem which could engage the manufacturer's responsibility.
Introduction
Summary
Meaning of the symbols
1. General safety instructions